Visually, the Reference 75SE hearkens back to past Audio Research products, taking inspiration from earlier amplifer designs. With its two large VU meters, which display power output as well as provide bias adjustments, the Reference 75SE has a timeless appearance resembling precision laboratory equipment and an overbuilt, industrious aesthetic. Offered in both natural aluminum and black finishes, the understated look will complement any system.

The KT150 vacuum tube delivers power from the amplifier to your speakers. Newly designed solely for the audio industry, the KT150 offers higher power handling and current delivery. A matched pair of tubes per channel run conservatively, ensuring stable operation and many hours of trouble-free listening. Custom designed capacitors couple the output of the tubes to the speakers for the purest signal possible.

The Reference 75SE is the new generation from a lineage of amplifiers only Audio Research could produce. Experience real music and unleash the capacity of your system ‚¬œ music in High Definition®.

POWER OUTPUT	75 watts per channel continuous from20Hz to 20kHz. 1kHz total harmonic distortion typically 0.6% at 75 watts, below 0.05% at 1 watt.Approximate actual power available at ‚¬˜clipping‚¬„ 76 watts (1kHz). (Note that actual power output is dependent upon both line voltage and ‚¬˜condition‚¬„ i. e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
POWER BANDWIDTH	(-3dB points) 7Hz to 60kHz.
FREQUENCY RESPONSE	(-3dB points at 1 watt) 0.7Hz to 75 kHz.
INPUT SENSITIVITY	1.4V RMS BAL for rated output. (25 dB Bal gain into 8 ohms.)
INPUT IMPEDANCE	300K ohms Balanced.
OUTPUT POLARITY	Non-inverting. Balanced input pin 2+ (IEC-268).
OUTPUT TAPS	8 ohms, 4 ohms.
OUTPUT REGULATION	Approximately 1.0dB 8 ohm load to open circuit (Damping factor approximately 8).
OVERALL NEGATIVE FEEDBACK	15dB.
SLEW RATE	10 volts/microsecond
RISE TIME	4.0 microseconds.
HUM & NOISE	Less than 0.06mV RMS ‚¬œ 112dB below rated output (IHF weighted, input shorted).
POWER SUPPLY ENERGY STORAGE	Approximately 520 joules
POWER REQUIREMENTS	105-125VAC 60Hz (210-250VAC 50Hz) 410 watts at rated output, 500 watts maximum, 230 watts idle.
TUBES REQUIRED	2 ‚¬œ Matched pair KT150 ‚¬œ Power Output; 2 ‚¬œ 6H30 Driver.
DIMENSIONS	19" (48.3 cm) W x 8.75" (22.2 cm) H x 19.5" (49.5 cm) D. Handles extend 1.5" (3.8 cm) forward.
WEIGHT	47 lbs. (21.3 kg) Net; 63 lbs. (28.6 kg) Shipping.